Start Grip Tape HF -1°...-20°C

Universal holding grease / holding tape with floor - Contains floor that ensures better sliding - For temperature -1°...-20°C - Suitable for all types of snow - Easy to use - One lubrication lasts up to 250 km - Package: 5m, for greasing 2-3 pairs of skis GRIP You can find the TAPE application video hereUser manual (see also the drawing in the package)

1. Clean the area where the skis are held (30-50 cm in the middle of the skis) thoroughly with a lubricant remover. Make sure the area is completely dry after cleaning.
2. Sand the cleaned area with the sandpaper found on the side of the product - side A (see drawing on the packaging). The entire holding area must be properly sanded, first transversely and then longitudinally.
3. Place the end of the Grip Tape at the start of the sanded grip area and press down. Apply Grip Tape to the entire grip area of the ski.
4. Cut the Grip Tape as follows: press your fingers on the brake, side C. Lift the box upwards. Press side D against the lubricating strip. Twist the cut end twice.
5. To avoid air bubbles between the lubricant and the ski surface, firmly smooth side E over the entire Grip Tape.
6. Remove the paper with a quick pull. If a few air bubbles remain, put the paper back in and iron again with the E side facing you and remove the paper.
7. Cool your skis outdoors. Don't touch the lubrication area with your hands and don't squeeze the nozzles together so that the lubrication areas don't touch.